Wheeled armored vehicles are designed for infantry transport and fire support. We supply hydraulic, suspension, and cooling systems, and develop and manufacture hydraulic cylinders and valves required for execution, as well as suspension systems that ensure ride comfort.
+Cooling Module Assembly
+Hydraulic Reservoir Assembly
+Manifold Assembly
+Bow Ramp Actuator
+Heater Radiator
+Gearbox Assembly
+Front Suspension Assembly
+Trailing Arm Assembly
+Rear Door Switching Cylinder
+Rear Door Locking Cylinder
Cooling Module Assembly
Mounted on top of the power pack, this assembly cools heat generated by the engine and hydraulic systems during vehicle operation.
Hydraulic Reservoir Assembly
Equipped with serviceable switch valves, this assembly stores operating oil used in wheeled armored vehicles.
Manifold Assembly
Supplies and blocks hydraulic pressure to each actuator according to solenoid valve signals.
Bow Ramp Actuator
Operates the bow ramp during maritime transport, allowing the vehicle to overcome water flow and debris while protecting the safety of the vehicle and driver.
Heater Radiator
Uses engine coolant heat(warm water) to supply warm air to the crew compartment via a blower in low-temperature environments.
Gearbox Assembly
Uses engine output to drive the water-propulsion fan located at the rear of the vehicle.
Front Suspension Assembly
Cools hydraulic oil used in armored vehicles by means of a radiator and cooling fan when the oil temperature rises.
Trailing Arm Assembly
Transfers impact loads from the road surface to the shock absorber.
Rear Door Switching Cylinder
Installed at the rear of the wheeled fighting vehicle that opens and closes the rear door using hydraulic cylinders.
Rear Door Locking Cylinder
Installed at the rear of the wheeled fighting vehicle to maintain the locked state when opening or closing the rear door.
